HWA epoxidová živica na odlievanie stolov

HWA DEEP UV 20KG

390.00  s DPH

  • Filling gaps and holes in the wood of various objects, etc.
  • Casting of thick castings up to 10 cm
  • Made for epoxy glass laminates
  • Creating mirror 3D coatings

Vypredané

SKU: 103 Categories: , Tags: ,

Description

EPOXY RESIN CONSUMPTION CALCULATOR

 

HWA PURE UV 20KG

(resin + hardener = A + B = 15.384 kg + 4.616 kg)

 

CHARACTERISTICS

  • very good resistance against UV radiation
  • easily poured
  • easily ventilated
  • excellent adhesion to various surfaces
  • low viscosity
  • high transparency
  • chemical and mechanical resistance
  • simple application
  • very low temperature rise during application
  • small linear shrinkage

 

PURPOSE

  • Filling gaps and holes in the wood of various objects, etc.
  • Casting of thick castings up to 10 cm
  • Made for epoxy glass laminates

 

The materials to be used should have an optimum temperature of 20-25 °C. The ideal temperature of the unmixed components A and B is 20-25 °C. At this temperature, the viscosity of the components is at its lowest, so the bubbles evaporate the fastest. In a clean container, mix component A with component B in the ratio A: B – 100: 30. Stir slowly with a stirrer for about 3-7 min. (To prevent excessive aeration of the material, it is recommended to use a turbine or basket stirrer at a speed of approximately 300-400 rpm.) You can then pour it into a mold. Due to the ongoing chemical reaction, it is necessary to apply the material after mixing, do not leave the mixed material in the container. The optimal ambient temperature is 20-25 °C, at which a gel like consistency occurs after 36-48h. With ideal parameters, it can be sanded down after 5 days.

 

TECHNICAL SHEET

Additional information

Weight 20 kg

VÝSLEDNÁ hodnota je v KG
* doporučujeme použiť 10%-20% rezervu

Cart
  • No products in the cart.